Barnes 4x4

This kit is designed to make it easy to swap the popular 63 Chevrolet leaf springs into your rig, this kit includes all the parts you will need to ...

Unleash the true potential of your 2007-2018 Jeep Wrangler JK or JKU, free up suspension articulation, and improve your off road performance with o...

If you are looking to convert your Jeep Wrangler TJ or LJ to a long arm link suspension we just made the process a whole lot easier.  Barnes 4wd i...

These hex capture washers are a great way to keep a bolt or nut from spinning on your rig. Simply plug weld the washer in place and around the oute...

These hex capture washers are a great way to keep a bolt or nut from spinning on your rig. Simply weld the washer in place around the outer edge ...

These axle link mounts are made to be welded directly to the axle tube. This is a super strong CNC bent, Laser cut bracket made to take serious abu...

These link mounting brackets are made to be welded directly to any square mounting surface. This is a super strong CNC bent, Laser cut bracket made...

These adjustable inner frame link mount brackets are made to be welded directly to your frame. This is a super strong CNC bent, Laser cut bracket m...

These mounts are made to be welded directly to your tubing. This is a super strong CNC bent, laser cut bracket made to take serious abuse. Perfect ...

When we are building a rig more time than not we find ourselves asking Where are we going to put all this stuff ? So we set out to try to find a wa...

Looking to add the best finishing touch to your tube work? Barnes 4WD has you covered with our Steel Tube End Spikes. Machined out of 1018 Steel, t...

This kit will insure that you get just the right parts to build your Panhard or Trackbar. Heims are 7/8 shank and you will run a 5/8 bolt on both e...

If you are looking to strengthen the Dana 35 or Dana 44 in the rear of your Jeep TJ or LJ Wrangler, or needing to convert the rear suspension to a ...

These tube link tabs are cut to fit a 1 ¾" tube but can be easily modified to fit other common sizes in a matter of minutes. These tabs are 3/16" ...

These inner frame link mount brackets are made to be welded to the inside of your frame. These brackets are made with strength built in due to the...

These axle link tabs are precut to fit a 3" tube but can be easily modified to fit other common sizes in a matter of minutes. These tabs are 3/16"...

Our axle link tower has 3 adjustable position that can be easily changed form 4-1/4, 5-1/4, and 6-1/4 inches from the center of the joint to the to...

When we are building a rig more time than not we find ourselves asking Where are we going to put all this stuff ? So we set out to try to find a ...

These flat bottom link tabs are made to weld to any flat surface. These tabs are 3/16" 100,000 min yield steel and have a 1/2" bolt hole. We offe...

These tube link tabs are cut to fit a 1 ¾" tube but can be easily modified to fit other common sizes in a matter of minutes. These tabs are 3/8 in...

These axle link tabs are precut to fit a 3" tube but can be easily modified to fit other common sizes in a matter of minutes. These tabs are 3/8 i...

These flat bottom link tabs are made to weld to any flat surface. These tabs are 3/8 inch thick steel and have a 1/2 inch bolt hole. We offer thr...

The Barnes4WD Universal axle truss is designed to be a strong attachment point for any link suspension on any axle. The truss is made from one piec...

Putting a 2005-up Ford Superduty Dana 60 front axle under your vehicle? Using the factory bushing mounts on the Superduty, this kit will make swapp...