Hatchet Series Front Frame Chop Bumper w/Stinger for Jeep JK / JKU
The Motobilt Hatchet Jeep JK Front Bumper with Stinger is an ultra-slim design for the front of your Jeep JK. The Hatchet is available in a few different configurations. This Hatchet configuration includes a stinger made from 1.75 inch DOM steel tube with integrated gussets. It has holes to mount your winch. The Hatchet includes 3/4 inch thick steel D-Ring mounts that pass through the bumper and our welded inside and out for superior strength. The Hatchet is a total of 41 inch wide which allows for closer approach angles. This is a frame chop design bumper. The front frame horns have to be cut off approximately 2"s and the bottom crash bar has to be completely cut off and removed from the frame. The areas that need to be cut are shown in the pictures. Also holes will have to be drilled through the frame rails in order to mount the bumper to the Jeep.
Specifications
- Hatchet Jeep JK front bumper with stinger
- Stinger made from 1.75 inch DOM steel tube with integrated gussets
- Approach angle increased by moving axle in 2 inches.
- Ships raw metal so you can customize to your needs.
- 3/4 inch thick steel d-ring mounts
- Hatchet is 41 inches wide
- Hardware included
- Sold as each
- Weight: 52lbs (approx.)
Note:
- Ships bare steel
- 2012 and newer Jeep JK frame modification required and vacuum pump relocation is required PN MB2060
- If installing a winch, MB1002 fair lead mount will also need to purchased
- Your frame ends and crash bar must be cut off and holes drilled through the frame rails. Does not use any factory holes.