Overland & Camping Gear

The RotopaX Standard Pack Mount holds a RotopaX gas or water pack on the vehicle so it stays at hand for the trip or an emergency. A base plate and...

ARB's TRED leashes give each recovery board a 59 in tether with a handle, so a board buried as the vehicle drives out can be found and pulled clear...

This kit pairs the HD Nomadic 180 LTE awning with its matching wall, so a lighter awning can still close in camp on a windy or buggy night. The 88....

The HD Bushveld 2 is a cantilever hard shell rooftop tent that sleeps 2. Its hard shell opens on a cantilever over a body of 280g ripstop polycotto...

The RotopaX Pack Mount Extension lets two packs stack together on one mount. It works with the Standard (RX-PM), Deluxe and LOX pack mounts and sui...

These Overland Vehicle Systems recovery ramps give a spinning tire something firm to climb in sand, mud or snow. They are injection molded from a d...

The Ruff Rax Tent Riser Bracket lifts a rooftop tent off the rack by 2 in, 4 in or 7 in, which opens space for an awning or lights along the side. ...

TRED Pro is the board in ARB's TRED range built from EXOTRED dual composite that is designed to resist damage under wheelspin. It is rated for vehi...

These ARB leashes attach to TRED Pro recovery boards so the boards can be found and pulled free when they end up buried after a recovery. Each leas...

This side panel is made for the HD Nomadic 180 LTE awning and blocks wind, low sun and blowing dust from the shaded area. The wall is 88.5 in tall,...

The RotopaX Mounting Plate is a black powder-coated steel plate that attaches to a rack, frame or trailer wall and holds a single 1, 1.75, 2 or 3 g...

The RotopaX LOX T-Handle converts an existing RotopaX pack mount into a locking mount. Swap it in for the current handle and the pack locks down, w...

This ARB bag holds a pair of TRED Pro recovery boards and keeps mud and sand off the rest of the load. It is made of waterproof canvas, with extra ...

The HD Bushveld Comfort Kit gathers the small things that make a rooftop tent livable: two high density foam pillows, a broom with dust pan and a l...

These brackets let a 180 or 270 degree awning mount directly to a Mamba III or Sidewinder hard shell rooftop tent, which frees up the rack when the...

On a mid or high roof van the awning sits high, so standard poles fall short of the ground. This HD Nomadic 180 kit adds 9.85 ft poles and three un...

The RotopaX LOX Pack Mount locks a RotopaX fuel pack or storage box to the vehicle with a keyed handle. Its design adds strength and tightening for...

TRED HD boards are made from a custom engineered nylon blend that flexes under load, rated for vehicles up to 9,900 lb. The SIPE-LOCK profile grips...

The HD Nomadic 180 swings out to cover the full side of the vehicle, where the table, chairs and cook station usually go. Boxed aluminum arms with ...

This kit puts the HD Nomadic 180 awning, its full wall and the mounting bracket kit in one box, so the side of the vehicle can be closed into a roo...

This kit lights a camp, tailgate or tent with four RGBWW LED bars that run from a USB or 12V accessory socket harness, with no hardwiring. Magnetic...

TRED GT boards are ARB's polypropylene recovery boards for sand, mud and snow, rated for vehicles up to 8,800 lb. The patented SIPE-LOCK profile gr...

The RotopaX L-Bracket Mount is a heavy-duty, black powder-coated steel bracket that gives a RotopaX pack mount a place to sit where no flat surface...

This wall fits around the full perimeter of the HD Nomadic 180 awning and turns the shaded side of the vehicle into an enclosed shelter, with a doo...

The RotopaX Deluxe Pack Mount holds a RotopaX or FuelpaX pack with added strength and tightening force. It can bolt down using the included base pl...

The RotopaX DLX T-Handle swaps into an existing RotopaX pack mount for added strength and tightening force under hard use. It is made from anodized...

This 47 in LED strip slides into the tongue and groove channel on the underside of a Nomadic awning or rooftop tent and lights the area below. It r...

This ARB annex zips onto an ARB Series III Simpson rooftop tent and encloses the space underneath it. The fire retardant room has insect screens an...

The ARB Flinders is a soft shell rooftop tent that sits lower than the ARB Simpson and sleeps two adults. Its removable aluminum ladder attaches to...

This small refrigerator tray slides out on stainless steel runners with sealed stainless bearings and then tilts, bringing the fridge contents with...

Mounting two HD Nomadic 180 awnings on opposite sides of a vehicle leaves open gaps at the front and rear. These 60.5 in wide connector pieces slid...

The HD Bushveld 4 Awning Extension zips directly to the Bushveld rooftop tent, with no brackets, drilling or modification, to shade the area at the...

This double slide-out tray carries a large or oversized refrigerator alongside a prep surface and a built-in sink. It runs on marine-grade stainles...

The RotopaX Bar Mount clamps to a roll bar between 1.5 and 1.8 in in diameter, with an included rubber pad to tune the fit. Any RotopaX or FuelpaX ...

The original ARB Esperance is a hard shell rooftop tent with a grey shell and black base band, made to mount on ARB roof racks. Gas struts help it ...

The HD Bushveld 2 Awning Extension adds a shaded, rain-shedding area next to the Bushveld 2 rooftop tent. It is 420D polyester rip stop with a 2000...

The RotopaX 3 Gallon Mount Extension lets a second pack stack on top of a 3 gallon RotopaX or a 3.5 or 4.5 gallon FuelpaX on the same mount. It len...

This fit kit lets RotopaX fuel and water containers mount to any Rhino-Rack Pioneer system, so extra supplies ride on the roof instead of in the ca...

These brackets mount recovery boards on the side of a Rhino-Rack Pioneer at a 75 degree angle, leaving the top of the platform free for other gear....

This fridge slide bolts into the cargo area and pulls a portable fridge out to the tailgate, so food and drinks are reachable without unloading. A ...

The RotopaX Road and Trail Emergency Pack ships empty so you can fill it with a first aid kit, gloves, drinking water, a phone or whatever the trip...

The ARB Esperance 2 is a compact hard shell rooftop tent that weighs 130 lb and packs to 60 x 49 x 13.5 in under a heat treated ABS shell. The tent...

The Overland Kitchen Kit stores 39 pieces, including 4 place settings, in a locking 6061 aluminum box with a two-stage powder coat. Three drawers w...

This bracket lays recovery boards flat on top of a Rhino-Rack Pioneer, so muddy tracks ride outside and stay ready for the next bog. Four upright l...

The RotopaX 4 Gallon Gas Can is a long, flat red fuel pack measuring 34.5 x 13.25 x 3 in, so it carries four gallons without much depth. It is roto...

A wrench roll keeps a full set in order so the right size is easy to find on the trail. This one is #16 waxed cotton duck canvas with double reinfo...

ARB's shoe pockets fit the Simpson III rooftop tent and give footwear a place of its own above the ground. They mount high on the tent, so shoes st...