OMIX

This grommet is used on the electrical contact pins on the tailgate and passenger side rear cargo area. Those pins power the center high mounted st...

This left tailgate bar bracket fits the driver side of vehicles with the soft top. It replaces OE 55176739AB. The right side bracket is 13510.30 an...

This rubber bumper stop sits between the hood and the grille. It is sold individually, with four used on the 87-95 Wrangler YJ and two on the 97-06...

This open back style pinion oil seal is made of steel with a rubber inner and can be used at the front or rear differential. It is intended for Dan...

This Omix hardware set is a replacement for the screws that attach a soft top to the header bar. It includes 18 screws and is intended for TJ model...

This is a replacement differential cross shaft bolt for Dana 44 differentials. It is listed as a direct OE replacement drivetrain part.Fitment: 90-...

This inner pinion oil slinger is for vehicles with a Dana 30 front differential and replaces OE 4031974.Fitment: 92-06 Jeep TJ with a Dana 30 front...

This rubber valve cover gasket from Omix is a replacement for 4.0L engines in the Jeep models listed. Omix lists it for 97-06 Wrangler TJ, 96-01 Ch...

This is a replacement idle air control valve for models with the 2.4 liter engine, covering the 02-04 Wrangler TJ, 04 Wrangler Unlimited LJ and 02-...

This Omix upper engine gasket set is for Jeep models with the 4.0 liter engine. It combines reinforced fiber, cork, MLS and viton materials and inc...

This Omix power steering pump pulley is a replacement part for 97-06 Jeep models. It is made of cast metal with a six ribbed design and replaces OE...

This is a hood bumper support screw from Omix.Fitment: 84-06 Jeep CJ/YJ/TJ Fitment Jeep CJ7 (1984-1986) Jeep Scrambler (1984-1985) Jeep Wrangler YJ...

This Omix push pin clip secures the inner fender and bumper. It is an OE style, direct fit replacement that replaces OE 6508712AA and carries a lim...

This Omix cylinder head gasket is a composite replacement for 4.0 liter engines. Use one per engine. It replaces OE 53020754.Fitment: 4.0L 96-99 Ch...

This rubber main crankshaft seal is for engines of 3.8, 4.0 and 4.2 liters. It replaces OE 3224704 and is backed by a limited 5 year warranty.Fitme...

This Omix heater blower resistor replaces the original unit that sets blower speeds. It mounts to the blower motor housing and regulates the speed ...

This replacement serpentine drive belt has 6 grooves and a 75in effective length. It is built from rubber that resists oil, heat and abrasion, and ...

This replacement door surround knob is sold individually, and four are required. It is an OE style, direct fit part with a limited 5 year warranty....

This Omix hood to fender bumper stop is an OE style direct fit replacement. It is sold individually, and two are required per hood. It carries a li...

This Omix inner windshield seal is a rubber replacement for the windshield weatherstrip on the 97-06 Jeep Wrangler. It replaces OE 55176430AD and i...

This kit supplies replacement knuckles for the soft top bows. It is an OE style, direct fit part covered by a limited 5 year warranty.Fitment: 97-0...

This hardware kit contains the screws and plastic nuts needed to install replacement fender flares. It is intended for OE style flares on the Wrang...

This heater core has aluminum core construction and measures 7.125 x 6.75 x 1.625in. It has a 1/2in inlet and replaces OE 5073180AA. It is an OE st...

This press in serrated wheel stud has a 0.61in knurl diameter, a 1.70in length and a right hand thread. It is for the rear on models with disc brak...

This rear outer axle oil seal is for Dana 44 rear differentials with flanged axles. It is sold individually, with two used per vehicle. It replaces...

This is a differential bearing cap bolt for Dana 30, Super 30 and Dana 44 differentials, as listed by Omix. It is sold individually and is an OE st...

This rubber outer glass seal from Omix fits the driver side door of TJ and LJ models with full steel doors. It replaces seals that have cracked or ...

This bolt secures the front hub and bearing unit to the steering knuckle. It is sold individually, and 6 are needed per vehicle, 3 per side. It rep...

This rubber door seal fits the front right (passenger side) door of vehicles with full steel doors. It replaces OE 5017462AF. For the left door sea...

This rubber full door seal from Omix fits the driver side door of TJ and LJ models with full steel doors. It replaces OE 5017463AF. For the right d...

This is a Trac-Lok differential disc kit with clutch discs and plates for Dana 44 rear differentials, with 30 spline. It replaces OE 994345 and is ...

This left side ball stud bolts through the liftgate glass and serves as the attachment point for the liftgate strut. It replaces OE 4883497AA. For ...

This Omix door glass channel is a replacement seal that fits around the upper door edge to hold the window glass. It fits either the left or right ...

This left (driver side) fender corner mucket seal mounts at the top corner of the tub behind the door opening. It acts as the mating surface for th...

This Omix kit replaces the outer pinion bearing in a Dana 30 front differential on 92-11 Wrangler models. It includes both the bearing and the cup....

This Omix oil pan is a steel replacement for 4.0 liter engines and replaces OE 53010340. The matching oil pan gasket is Omix 17439.06.Fitment: 4.0L...

This is a metal replacement rocker arm pivot for engine rebuilds and repairs. It is direct fit and backed by a limited 5 year warranty.Fitment: 72-...

This Omix inner axle seal is a steel and rubber part for vehicles with a Dana 30 front differential. It fits either the left or right side and is s...

This Omix rubber seal is the right (passenger side) replacement for half doors on the 97-06 Jeep Wrangler. It replaces OE 5017010AB, and the matchi...

This is a left side half door seal made of rubber for the Jeep Wrangler. It is an OE style, direct fit replacement for the driver side half door. T...

This Omix lamp socket assembly replaces the original socket on 72-06 CJ and Wrangler models. It is an OE style, direct fit part sold individually.T...

This Omix set includes left and right headlight assemblies with two housings, two retaining rings and two sealed beam bulbs. It replaces OE 998972K...

This replacement parking brake cable fits the rear passenger side and is for models with rear disc brakes. It is an OE style, direct fit part. The ...

This Omix headlight assembly is for the right (passenger) side. It includes the headlight bucket, a halogen bulb and a retaining ring. For the left...

This driver side headlight assembly is a sealed beam unit that includes the headlight bucket, a halogen bulb and a retaining ring. It replaces OE n...

This replacement tail lamp lens has a red lens with an integrated clear reverse reflector. It fits either the left or right side, is sold individua...

This clear multifunction bulb is a replacement for tail light use. It comes from the Omix line of OE quality replacement parts for Jeep and Willys ...

This amber side marker lamp fits the front passenger side and is sold individually. The left side lamp is 12401.07. It replaces OE number 55155628A...